ALISHA-SUE-PENELOPE Arduino Nano Package For 3D Printed Iron Man Costume/Cosplay

Description

A.L.I.S.H.A. - S.U.E. - P.E.N.E.L.O.P.E.We now have available these 3 great components to make it even better to create your own favorite cosplay or costume experience with special effects!A.L.I.S.H.A - Arduino nano LED & Integrated Servo Helmet Actuator version 2.0 is a simple to install Arduino Nano shield module that allows DIY people to easily motorize and light up their favorite 3D printed Iron Man helmet or any other helmets (i.e. Batman, Gray Fox, etc.). Drives up to 2 MG90S servo motors (recommended), 2 LEDs independently controllable for eyes (PWM), 1 button/switch, 1 auxiliary LED port (non-PWM), and an expansion port for additional features.Recommended operating voltage between 5v-6v (not to exceed 6v due to MG90S servos.)Each LED port has a 100ohm current limiting resistor.Includes:Board with JST-XH connectionsArduino Nano with CH340G driverMale JST-HX pin headers for easy jumper wire connection - 2x3 pin, 3x2 pinBoard Sizes:MK-2: 70mm x 70mmMK-3: 55mm x 55mm*** USB cable, Servos and LED eyes not included. ***S.U.E. - Sound Unit Expansion is a DFPlayer Mini sound module designed to easily integrate with ALISHA and enabling you to add sound effects to any helmet or suit. Sound files can be downloaded from the Crash Works 3D GitHub Page.!!! IF ORDERING S.U.E. ONLY, PLEASE MESSAGE US WHICH A.L.I.S.H.A. BOARD YOU CURRENTLY OWN (SMT OR THROUGH HOLE !!!Includes:Board with integrated DFPlayer Mini moduleJST-XH female pin headers, 1x2 pin and 1x6 pin connection cablesBoard Size: 50mm x 40mm*** Speakers and SD card not included. ***PENELOPE - Powerbank Keep Alive Load Pulser This USB Power Bank Keep Alive version 2.0 is a simple to install module that allows DIY people to easily keep their USB power bank from deactivating at the most inconvenient times during Coplay or fighting villains!If you wish to purchase PENELOPE only, please visit our individual listing here: http://www.ebay.com/itm/402633479296Includes: Board with USB connectionsBoard Size: 300mm x 350mm*** USB cables not included ****** The power input connector is a USB-Mini (same as on an Arduino Nano) & the power output is a USB-A (Standard Size) ***Full documentation, instructions and code can be found on the Thingiverse Crash Works 3D page and Crash Works 3D GitHub Page.(We apologize but eBay does not allow external links in their listings.)